[railML3] Need for midOfTrain [message #2852] |
Mon, 29 November 2021 11:21 |
Milan Wölke
Messages: 146 Registered: April 2007
|
Senior Member |
|
|
Hi guys,
in railML 2 it was possible to specify for an ocpTT that a train stops with a certain alignment and offset at a stop. The alignment was defined as an enum with the possible values of head, center and rear.
In the context of railML 3 modelling the IS group raised the question if we would still need the option to specify the place for a train to stop regarding its center, or if that is not needed. What is your opinion? Are you using that value in railML 2?
Do you think we should keep that option for railML 3 as well?
---
In railML 2 war es möglich, für einen ocpTT anzugeben, dass ein Zug mit einer bestimmten Ausrichtung und einem bestimmten Abstand an einer Haltestelle hält. Die Ausrichtung war als Enum mit den möglichen Werten head, center und rear definiert.
Im Zusammenhang mit der Modellierung von railML 3 hat die IS-Gruppe die Frage aufgeworfen, ob wir die Option, den Ort des Halts eines Zuges in Bezug auf seine Mitte zu spezifizieren, weiterhin benötigen oder ob dies nicht erforderlich ist. Was ist eure Meinung? Verwendet ihr diesen Wert in railML 2?
Sollte diese Option auch bei railML 3 beibehalten werden?
Best regards, Milan
Milan Wölke – Timetable scheme coordinator
railML.org (Registry of Associations: VR 5750)
Altplauen 19h; 01187 Dresden; Germany www.railML.org
|
|
|
|
|