[railML3] measure and distance in linear positioning systems [message #3289] |
Fri, 30 August 2024 10:35 |
christian.rahmig
Messages: 458 Registered: January 2016
|
Senior Member |
|
|
Dear all,
have you ever wondered what the attribute @measureToNext in //linearPositioningSystem/anchor/ is used for?
If not, you may be aware of the best practice documentation on the wiki page of the <anchor> element [1]
However, the attribute name @measureToNext is little bit confusing. because the other anchor attribute, which describes the linear position value, is named @measure, too. What @measureToNext actually describes is a distance. It is the distance from this anchor until the next anchor or until the end of the linear positioning system. Therefore, I suggest to rename @measureToNext into @distanceToNext. The topic is already documented in a new ticket [2].
What are your ideas on this proposal?
What about the datatype for the @distanceToNext? Shall it be fixed with tLengthM in metres, or shall we leave the unit open to be decided by the user (@units is an already existing attribute in linearPositioningSystem)?
As usual, any feedback is highly appreciated.
Best regards
Christian
[1] https://wiki3.railml.org/wiki/RTM:anchor
[2] https://development.railml.org/railml/version3/-/issues/566
Christian Rahmig – Infrastructure scheme coordinator
railML.org (Registry of Associations: VR 5750)
Altplauen 19h; 01187 Dresden; Germany www.railML.org
|
|
|