Forum: railml.interlocking

Home » railML newsgroups » railml.interlocking » Partial Route (Route release group)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Partial Route [message #2006 is a reply to message #1616]

Mon, 05 November 2018 17:08

Fabiana Diotallevi
Messages: 21
Registered: October 2018

Junior Member

Hi,
I would like to bring this topic up because I have some questions about the partial routes.
As far I understood, if the interlocking releases each individual tvd section after use, the release group of the knowsRoute can be omitted.
However, in this case, there would be no information about the tvd sections that compose the route.
On the other hand, one could avoid this by defining a partial route for each tvd Section (as done in the simpleExample), but in this way the information would be redundant.

I was wondering whether it makes sense to reference direclty the tvD sections that compose the route as an alternative to the partial routes.

What do you think about that?

Regards,

Fabiana

Report message to a moderator

[Message index]

		Partial Route By: Bob Janssen railML on Fri, 23 June 2017 16:24
		Re: Partial Route By: Fabiana Diotallevi on Mon, 05 November 2018 17:08
		Re: Partial Route By: Joerg von Lingen on Wed, 07 November 2018 05:17
		Re: Partial Route By: Fabiana Diotallevi on Wed, 07 November 2018 10:35
		Re: Partial Route By: Joerg von Lingen on Sat, 17 November 2018 06:23
		Re: Partial Route By: Fabiana Diotallevi on Tue, 20 November 2018 11:41
		Re: Partial Route By: Joerg von Lingen on Mon, 26 November 2018 06:14

Previous Topic:	Overlapping or gapping track section borders
Next Topic:	railMLv3: TVD Section demarcatingTrainDetection

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 03 20:44:29 CET 2024