Re: [railML3]: operationalPoint of operationalType="block" [message #2692 is a reply to message #2689] |
Fri, 09 April 2021 13:54 |
christian.rahmig
Messages: 465 Registered: January 2016
|
Senior Member |
|
|
Dear Dominik,
in general, your approach of locating the <operationalPoint> on a microscopic <netElement> is fine.
However, I don't understand why you want to locate an operational point with a length of zero meters using an <areaLocation>? I think, a <spotLocation> would suit better.
By the way: locating <operationalPoint> elements on microscopic topology is quite common. In particular, it is best practice to model the operational point center point (in railML2 language also known as "cross section") using a <spotLocation> on a microscopic <netElement>.
Are there any other best practice ideas from the community?
Best regards
Christian
Christian Rahmig – Infrastructure scheme coordinator
railML.org (Registry of Associations: VR 5750)
Altplauen 19h; 01187 Dresden; Germany www.railML.org
|
|
|