Switch/Derailer/Crossing in Overlap requires a position [message #3108] |
Tue, 25 July 2023 14:30 |
heidrun.jost@thalesgroup.
Messages: 5 Registered: December 2022
|
Junior Member |
|
|
Dear all,
for the route overlap definition, a position is required for a switch/derailer/crossing in an overlap.
But sometimes this position is not available, because a) the overlap ends before the heart or b) does not matter.
Using only the TvdSection is not a solution, because it could include several switches/derailers/crosings, which would then be to much.
<overlap id="IL_FMkw4WGpByf8V0i0u539i9" length="55">
<designator register="_costId" entry="Overlap:BGS_MR#1564"/>
<requiresSwitchInPosition>
<relatedSwitchAndPosition inPosition="right">
<refersToSwitch ref="IL_Z8wATeoLQQL7NLmHuC2c8Ca"/>
</relatedSwitchAndPosition>
</requiresSwitchInPosition>
<hasTvdSection ref="TVD_Z8wATeoLQQL7NLmHuC2c8Ca"/>
</overlap>
So the parameter "inPosition" shall become either optional or provide an additional option for these cases.
Best regards,
--
Heidrun Jost
Data Manager TMS Norway
Ground Transportation Systems
Phone: +49 (0) 30 688306 423
Schützenstr. 25 10117 Berlin Germany
|
|
|